connection method of multi-layered warning lights

applies to:

LTA-205 1/2/3/4/5 & nbsp; Flash & nbsp; DC12V, DC24V, AC110V, AC220V

LTA-205 1/2/3/4/5 & nbsp; Flash & nbsp; DC12V, DC24V, AC110V, AC220V

LTA-205 1/2/3/4/5 & nbsp; Brightening & nbsp; AC110V, AC220V

LTA-204 1/2 / 3/4 & nbsp; & nbsp; Flash & nbsp; DC12V, DC24V, AC110V, AC220V

For example: & nbsp;

The following is a model: & nbsp; LTA-205, Voltage: AC 220V, layers; 3 layers, W-type flash.

There are six lines light.

1 Translation Description: green arrow two bonded black line for the power cord, when the light starts to work, first of all, these two lines must be outside power connection. There is no limit negative level.

warning, black 2 wire must not be connected with the other four lines to the external power supply, otherwise the consequences.

. 2 Translation Description: The green arrow comprehensive color line is the signal common line, when the power cord and external power is connected, only this entry-level line and the other phase corresponding bare wires, lights that work, examples, see Figure 3.

. 3 Translation Note: The figure shows the signal line has been public and other corresponding red, yellow and green lines connected, once the black power cords and external power connection, this red, yellow green three lights begin work immediately.

Description: The red line represents the red hood level, yellow line represents the yellow cover level, green line represents the green cover levels

further added:

When the external power supply and two black wire, connected to the common brown and red lines, the red light; dictates, brown and yellow wire is connected to the line, the yellow light. .

If equipped with a buzzer, the gray line represents the buzzer. The equivalent of a level. If allowed to work only with the common line is connected to the gray line.