Hotline
Small warning lights daily troubleshooting
When a small warning light fails, please understand electrical professionals in the following table to check if you still can not exclude Check with your local service center or contact our head office.
1 , turn lamps
Symptom | Therefore, barrier original because | Pai except Square France |
Do not turn | ① motor damage ② power supply circuit breaker | ① replace the motor ② reconnect lines |
Not bright | ① bulb damage ② contact point oxidation ③ wick line circuit | ① to replace the lamp ② remove the oxide layer ③ Replace or reconnect wick line |
2 , flash class
Symptom | Cause | Remedy |
No flash | ① fuse burned ② power supply circuit breaker ③ the lamp is damaged (check the lamp is broken, black, leakage is already bad) ④ content or high-voltage switching transistor is damaged (check the high voltage across the capacitor voltage is ≤ 300 V | ① replace the fuse ② reconnection line ③ lamp replacement parts ④ There ≥ 300 volts, replace the lamp parts, no replace the high-voltage content or switching transistor, still does not flash , replace the whole PCB. |
repair and maintenance
This product transportation and storage Note: You must light up with light, not on a wet storage places.
The alarm device belongs to electronic products, no sealing performance, a drop of water after the installation is prohibited to enter the alarm device, so please do not store a variety of wet objects on the alarm system.
As to meet the issues raised in the course of more than four, repair in accordance with the method described above.
